Heat & Condensate Vent Hoods
Exhaust-only hoods are to be used over equipment that does not produce grease-laden vapors. Hoods have fully welded 10-gauge corner hanging angles, and hoods over 12' have additional fully welded 10-gauge center hanging angles. Hat channels and trim strips are installed on top of the hood and have been designed to make the top of the hood rigid. This allows installation without damaging the top roof panels. This series of hoods has been created using the latest solid modeling software. The manufacturing and assembly processes being used are state of the art. Each hood goes through a rigorous computerized quality control system designed to ensure the very best products are shipped to the customer.
- Single wall or double wall construction.
- Available in wall type or one-piece island.
- 430 stainless steel used on standard construction hoods.
- 304 stainless steel used on hoods with full-perimeter gutters.
- Hoods with full perimeter gutters have a drain.
- Hoods that have full perimeter gutters have welded corners.
- Double-wall hoods have insulated fronts.
- Double-wall hoods offer rigidity and help guide moisture-laden air and heat to the riser and away from the front of the hood.
- Incandescent, LED, and fluorescent lights are available.
- Hoods are offered in multiple widths: 24”, 30”, 36", 42", 48", 54", 60", 66”, and 72”.
- Hoods are offered between 24" and a maximum of 120".
- Hoods are offered in multiple heights: 12", 24", and 30".
- ETL Sanitation listed and ETL listed.